About ccatindig

ccatindig · 10-23-2012

Hi everyone.I have a client with two Catalyst 6500Es in VSS and four stacks of 3750 switches. Each stack is dual-linked to the 6500E core using two port channel links. There is a small Netgear switch connected to stack 1 with less than a handful of P...

ccatindig · 09-27-2011

Hi!I need immediate help with a particular coax cable between a MGX and a Cisco 3845 router. The router has a NM-1A-T3/E3 network module (most likely since the label that the guys onsite saw at the back of the router says 1A-T3.The MGX meanwhile has ...

ccatindig · 04-22-2004

We had a MALLOC failure with a couple of 7609s recently. Does anyone know if this problem is prevalent with this platform? We are running IOS 12.2(14)SX1 in both 7609s. Both chassis has two SUP720s.I was recommended to upgrade to 12.2.17d-SXB. Where ...

ccatindig · 02-05-2004

I have a 7609 with interface FastEthernet8/47, IP address 210.14.31.74/29. This interface links a NetCache web cache engine w/ IP address 210.14.31.73/29. I can PING both ways. Whether I use WCCP version 1 or 2 in my 7609, I don't see the NetCache's ...

ccatindig · 10-11-2011

Hi Paolo.Thanks. Is this Cisco's corresponding coax cable product?15454-CA-HDBNC-30= Cable assy, Mini-BNC to unterm (BNC provided), 735A, 30ft

ccatindig · 11-10-2010

Hi. Good afternoon.So a Cisco 3845, with FOUR HWIC-2CE1T1-PRI (64 x 2 = 256 channels) and ONE NM-8CE1T1-PRI (128 channels), will support a total of 384 channels? The 3945 however will support a total of 512?Whre 512Kbps links are required, binding ei...

Member Since	‎06-03-2002 08:49 PM
Date Last Visited	‎09-25-2019 12:21 AM
Posts	9

User Statistics

User Activity

Overlapping IP subnetworks

HelP: DS3 coax cable needed

MALLOC in 7609

Can't see the cache from my WCCP router

HelP: DS3 coax cable needed

Re: Channels on NM-8CE1T1-PRI on Cisco 3845 Router