Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am working with a new ISR4331 and outgoing dial peers are not matching [range of digits] properly.
Dial-peer 100 should match 00100~00999, but it doesn't.
I get 'no match' when the second zero is entered. 00 = 'no match'
!dial-peer voice 100 pots...
I know how to pass the MAC of a phone using: http://hostname.tld/?name=#DEVICENAME#I want to know how to pass the user locale for a subscribed IP Phone Service.Does anyone know what other parameters are available for use? Where is this information d...
Is there any way to scale down the available options in Cisco Personal Communications Assistant/Cisco Unity Assistant?There are a few controls in CUC Administration that translate to options available in CPA/CUA. Such as the ability for a user to ch...
Using the 8851 SIP phones.
BTW:
The dial-peer would be applied properly when sending the full dial string from the phone. Enter all the digits and press place call.
The issue was when a line was selected, with the open connection tone. When dial...
I actually discovered the answer. The sip phone KPML (keypad markup language) does not handle dial-peer destination-patterns properly. Specifically, KPML does not support the range parameter.
So the dialing fails when it encounters a digit range.
...
Is your Cisco Unity integrated with MS Exchange and AD? I had a similar issue related to process load on the Exchange/AD server.On the surface, Exchange/AD appeared to be working just fine, but the underlying connection would take longer and longer ...
My two cents...Whenever possible, MGCP is the way to go. It's a mature technology for PSTN connectivity. It does lack some of the flexibility of other protocols, but that also adds to it's stability.MGCP allows the Call Agent (CUCM, Asterisk, etc) ...
Something to consider, you can encounter issues by the simple act of turning off a server that has been running for days/months/years.Before upgrading, you should do a sanity check. Complete power down, complete boot, then power down for the upgrade...
