Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cisco C1111-8PWA router running 17.12.4. I recently initialized the wireless module (ISR-AP1100AC-A) that is running 8.8.100.0 but can't get the C9115AXI-B to work with it. I receive an endless list of error messages (view attached) and ha...
I have a C1111-8PWA I am setting up for the first time and am trying to set up the Embedded Wireless Controller through the Web GUI. I get to the page and it says "Please make sure Wireless Controller is in Login prompt as "User" Click here to Login...
I have an ISR111-8PWA that I purchased several months ago. I have been having all kinds of difficulties just connecting to my router and accessing the internet. The latest config is attached as well as a picture of what comes up when it tries to co...
My computer can reach the router, the router can reach the ISP ( Spectrum), the ISP can reach the DNS server but the ISP can’t reach the internet. In the webgui it fails the WAN test. Here is my configuration Building configuration...Current configur...
I was having issues in setting up a C1111-8PWA-WS for the first time and decided to start from scratch. Unfortunately I used the factory-reset all command instead of using a paper clip in the button on the back of the unit and now I am in rommon mod...
The error messages are in the picture I attached. When I access the AP through the console port I get an unending stream of messages and cannot get to the command prompt so I'm not sure how to capture an error log. running config is attached
The router came with 16. I upgraded to 17. did that also change the AireOS? What do I have to do to make it work? Upgrade the AireOS on the wireless module?
I see the said I set up and can access the controller with a browser directed to 192.168.1.7 on my phone. The wifi light on the face of the router is steady green. I can now access the controller from the router's GUI so it looks like all is workin...
I went back and started from scratch. Specified static for the ip address and used 192.168.1.7 255.255.255.0. The controller is all set up and I can access it on the CLI. However, when I try to access it from the GUI it still says credentials fail...
