Hi Shoeb,Good Evening! I'm not pretty sure on what are the exact configuration on your network but I assume that the router is only pass through and the PIX will do all the NAT configuration, right?If that is how you would like to implement your net...

Hi Earl,Good Day! Its not possible to omit the last 0 because once you configured 'channel-group x timeslot command' a serial interface is created and x(channel-group number) will be at the end of the serial interface just like what you have on your...

Hi Greg,Good Evening! You may refer to the link below.Serial Lines: Increasing Output Drops on Serial Linkhttp://www.cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a00800a758d.shtml#topic3I hope this helps. Best Regards,Ansley R. Verzo...

Hi Erick,Good Day! When both ports on a VWIC-2MFT are configed as clock source line, then clock is being provided by the remote ends and it must ultimately be sourced by the same timing reference. Otherwise slips will occur. You choices are to eithe...

Hi Sam,Good Day! Are you looking for E1 PRI adapters. Here are some of the E1 port adapters that 7204 router supports.*PA-MC-2E1/8E1 PRI*PA-2CE1*PA-MC-8TE1+You may also refer to the links below for more information about the above mentioned port ada...