Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hypathetical scenario: I have a trunk port on a router going to a switch with subinterface fastethernet 0/0.1 for data, and 0/0.2 for voice. I want to perform LLQ or prioritize voice traffic on the 0/0.2 subif. Even though both data and voice have th...
Sorry to resurrect this but I have a couple clarifying questions. Is there another option outside of changing the service parameters since this may introduce some unknown side effects of existing call flows?What is the default mechanism that CUBE use...
Hello,This may not be what you want but this document (under wan considerations) may lead you to the info you need to do a granular policy. One other consideration depending on your topology would be to classify based on the layer 3 addresses of the ...
OK, here are the issues that I see: In order to filter this traffic the way you are describing, it needs to be done inbound to the router. This means that the ACL needs to be applied in the "in" direction of the outside interface. (I am surprised yo...
Hello,I am assuming that your dial peers are already configured properly. If so you can run a "debug voip dialpeer" and this should show you if there was an outgoing DP match as you make a call. If there is a match, make sure the phone line is connec...
