Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, We are looking at deploying ISR 4431 routers to replace some older 1811's.If I have understood as well, The module evidenced "1xNIM-ES2-8 and NIM-ES2-8-P" should act like a two switch inside the ISR; numered with syntax interfaces like VSS, na...
We are trying to set up some topology interconnected with ASA, in the specificSwitch 3750(here are localized the client) - 6500 (VRF CERT without RD)- FW ASA 5520 TRANSPARENT mode- 6500 VRF CERT-SEC with Route distinguish...
I have setup on Nexus 7K of my customer, but I noticing that traffic Egress was expected on port and vlan different.
In addition vlan 128 doesn't exist on my platform.
Can someone help me to undestanding?
Nexus# sh vl id 128VLAN 128 not found in cur...
Are there and What is best eligible tool ( in call manager 10.x) for troubleshooting about number matched in multiple route pattern?
Does command "debug isdn q931" in Voice gateway can assist me? (Q931 is mostly used in my infrastructure)
Any sugge...
My customer wish to block one international inbound number toward my internal IP phone (not outbound,however from IP phone is blocked by CSS) in my Cisco Unified CallManager.
I have not any gateway neither MGCP or H323, but the call hits CUCM direct...
I have time to implement the solution, mostly I used through this link:
https://supportforums.cisco.com/document/71966/blocking-calls-based-calling-party-id
thanks for support.
Hello,
Sorry for my english Jaime I told green number as Toll-free telephone number identified with dialing prefix, something like 800 or 1-800.In my company we have two toll free number (equipped with phone agent and linked on device profile) one s...
Hi Philip,
yep previously there was asymmetric routing and then I try to fix with static /32, at the moment I have just /32 route vs firewall, as side firewall has two /32 route too, one for LAN pointing layer 3 next hop of S1 (source) and other one...
