Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I see the following configured in a device and I was wondering if I could get some insight on what exactly the following means (this is the full configuration of the track list):track 2 list boolean or object 1 not!ip route 0.0.0.0 0.0.0.0 x....
Thanks for bringing that up, that was actually another question I had that I forgot to ask. What is "object #" suppose to be? I don't see anything in the configuration outlined as "object 1". Is it suppose to be track 1? If it is, then track 1 appear...
Hello,A little late but the following is my review:As both the access and core switches are stacked (I am assuming based on your usage of stackwise that this is not Nexus devices), I would keep the port-channel #'s the same for ease of management. Al...
You'll need to check the Access Rules between the LAN and WAN zones. Keep in mind that these zones may be labeled differently on your device. By default, there should be an any to any from LAN to WAN but it may be possible that it was removed for se...
Hello,I haven't seen any mention of ensuring the Sonicwall is even allowing the VLAN 30 subnet through to the Internet. Has this been even verified yet?
Just to clarify, you have "permit ip any any" or something equivalent at the end of your TEST ACL. Also, when you try to ping the E1/1 interface from another device, it goes through. Is this correct?If so, I can't think of anything else at the moment...
