Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I am not well versed in Telephony, so any answers, please keep it simple. I had an event occur recently where phones began to de-register from Call Manager. No configuration changes were being made, nor had there been any recently. We noticed ...
Hello,
I am running nxos 7.0(3)I7(3) and I'm confused on why I can't get a simple access list to work.
Maybe it's my unfamiliarity with the Nexus OS.
I am trying to block ICMP ping requests with the following:
ip access-list TEST 10 deny icmp any...
Hello All,
I'm looking for a solution. I have a 4331 ISR that is currently in production and working fine. Though I have some very specific pings that fail and I'm trying to figure out why as it is making it difficult to troubleshoot other things. I...
Hello,
I am remotely (ssh) working on an active, productive switch that I accidentally locked and I need a solution. While attempting to test the configuration replace command, the switch didn't take the rollback and stopped me from issuing any furth...
C6880-X-LE on Version 15.2(1)SY4CDP seems to be working correctly. It is enabled on all ports by default and the counters have continued to show traffic.
I'm going to open a ticket with TAC to see if they can figure this out. Keep the ideas coming though if anyone else thinks they might have a solution.
I tried adding the ip access-list match-local-traffic command but I'm still getting the same beha...
I can provide you with some of it.
DR_3K_1# sh verCisco Nexus Operating System (NX-OS) SoftwareTAC support: http://www.cisco.com/tacCopyright (C) 2002-2018, Cisco and/or its affiliates.All rights reserved.The copyrights to certain works contained i...
Hi Peter,
I've added the "permit ip any any" & "statistics per-entry" to the ACL and have posted the output of the show commands below. I'm definitely getting matches on my pings. I kept rerunning "sh ip access-lists TEST" and was seeing an increme...
The switch has only one active port, the one I posted. So all traffic is traversing that link. And you bring up another good point. Applying any ACL to a port should deny all traffic without a permit statement.My setup is as follows:I'm configuring v...
