Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Infrastructure:WLC2500, PEAP MS Chapv2 authentication thru a single IASPCI WLAN with AD Security groupInternal WLAN with AD security groupScenerio:I need to set up seperate authentication for each WLAN with it's appropiate AD security group. In othe...
WCS 4.2.81.0WLC 4.2.112.0Loc 3.1.36.0I have a very large map with currently 40 APs placed on it. Tt will have close to 80 when completed. Layer that are on:APAP HeatmapsClientsRogue APsResaved AP placement and recalc RF prediction. Antennas are all ...
I'm deploying a LWAPP solution over a MobileAccess distributed antenna system (DAS) using AP1242s. the A & B/G antennas are connected to the primary (right side) antenna outputs. The 4404 WLC (wireless->access points->radios->802.11a/n or 802.11b/g/...
I to have a similar issue with rate limiting the Guest Services Protocol97 (EoIP) Tunnel to 500K of a T1 at each site. My variation is I have access to both DC and Site routers for configuration, but have never rate limited a pass-through layer 2 tu...
Security concerns around a LAP growing legs and walking away with my network configuration for locally switched WLANs.Are there any configuartion changes that can be made to limit a HREAP/Flexconnect LAPs configuarion availability before it must be r...
Fixed that and had to change AP Antennas to defualt rubber ducks. The 'Other' selection doesn't seem to have a radation pattern associated with it.Thanks