Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
See below config. All IP Addresses are correct and I have other AP which works. However, this one does not. They are using the same RADIUS settings.On the client machine I am getting a EAP/TTLS box asking for Domain/Username and Password (Token). If ...
HiI am looking to deploy IPS Modules in my ASAs but I still need to keep them is transparent mode. Is this possible?Can you provide any sort of Cisco links to also confirm this and how it is done?Thank you very much is advance.
I am getting the following errow message while trying to create a VPN tunnel between an ASA5520 and a 2921 router. Config attached. Please helpError MessageSep 22 16:28:48.150: %CRYPTO-6-IKMP_NOT_ENCRYPTED: IKE packet from 63.240.91.172 was not encry...
Below if the event from the NPS Server. Instead of "guest" it normally says the user login name.Log Name: SecuritySource: Microsoft-Windows-Security-AuditingDate: 1/19/2012 11:51:45 AMEvent ID: 6273Task Category: Network Pol...
I have a MS CA server which is currently issueing to every users.I want to use the PSK, Certificate and the users still have to enter the username and password.If not, Can I just use the Certificate and the username and password.
