Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We replaced an old touch10 with new touch 10 and its not showing in control hub and also not going to Welcome page i suspect the issue is in software version and sx80 is running RoomOS 9.15.18.5 and the touch 10 is running RoomOS 10.8.3.1 .Please gui...
Hi Webex community,We recently replaced our old Cisco Touch T10 with a new one. However, we're encountering difficulties logging into the admin. Webex panel using the correct email and password. The specific error message is shown in the attached im...
Hi Yes already did that both are on the VLAN and network. Also, we connected the Navigator to 2 port of the codec and via poe still nothing . can you please say the usual process of pairing a new device with sx80 I must be making a mistake over ther...
