Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,for along time, i was using group policy with L7 rule to accept outgoing traffic to a certain country. and to add a published server to this group policy. this way, the published port is only accessible from this country. which helps a lot against...
Hi,i wounder if there is a way to connect an iPhone device as a client vpn for MX device, and apply the Split Tunnel.so that any traffic for the destination LAN are tunneled, but other traffic like internet is sent directly.i found an article for the...
Hi,I am having an issue where i am managing a network using Meraki switches, and having a Vlan for the IP Cameras, and a separate Vlan for IP Telephony, etc...the point is that from time to time, i find some cameras connected to the staff Vlan withou...
Hi, I've an MX 84 and it is working fine as configured. i am thinking of getting benefit of "Advanced Malware Protection (AMP)" and "Intrusion detection and prevention" features available on MX. i am thinking of getting my servers on a separate non-m...
Hi, i wonder if there is anyway that i can apply a group policy on MX unit (Network-wide-->Group policies) to an IP Range, or a whole subnet -if i have a layer 3 network. because what i am doing is to create a new group policy and wait for the desire...
Hi,I am subscribing for the RSS Feed for this one.may you please update this topic when the feature is out and configurable.it is a long waited feature.regards,Ahmad Qattan
Hi, as much as i understood from this article earlier, and my working on MX since i had an answer. it will not work. To have a L3 Switch with Vlan interfaces configured on, and to have the MX unit after this switch. this setting will lead you to the ...
Hi Philip, thanks for the reply, what about i connect the server's switch to a Internet Port, but with transparent mode. not nating mode. will this be any good. thanks
Hi Michal,
i would like to thank you for your help, you have pinpointed the problem from the first shot.
one extra question if you may.
we already applied the SYSLOG on all switches from day 1. i was not noticing major or repeated topology changin...
