Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i want to know can i configure two cisco 2811 with G.SHDSL HWIC (with Cisco ISO 12.4T-15)installed in back-to-back operation that one of my Cisco 2811 setup as CO (central Office) and the other one in CPE mode when i only have copper lines (without D...
Hi.i am intended to find some way to counting the total ACL hit on by border Routers/Switchs as a base-lining method and detect the DOS attack facing my network.after 2 month searching cisco and googeling i find no explicit way to do that (for examp...
thanks to your reply.but there are some issues :1-the url that you mentioned , obviously describe that only HWIC-4SHDSL supports both CPE and central-office modes for diagnostic purposes and only in ROM monitor mode.2-some people argue (in this forum...
Hii have same problem.it take too much time for me.i think the problem are :1-you need to upgrade your current IOS to 12.4T(6) or later.2-i think only Cisco ISR-878 G.SHDSL and old G.SHDSL-v3-WIC (not HWIC) support back-to-back3-FAQ for G.SHDSL HWIC ...
to solving this problem , i complete my last effort and complete my Shell-Script to work bug freee.that work fine , and now i have a baseline for Dropped packets and detect spikes on ACL occur on Edge-devices.what i do was :1- send SYSLOG from my pol...
you are right Davistan.but think about how it can be useful if you be able to count the ACL Hit on your policy enforcement devices.Netflow is perfect but what it give you just traffic accounting.i believe Base-line methodology with Netflow don't let...
it seems there is not any MIB support for both Security ACL / QOS ACL.i use "snmpwalk" to browse the full MIB Tree on cisco gears but there wasn't any useful information (even about the ACE list , ACL name , ...).i am wonderful regarding to Cisco MIB...
