Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I have two pools DHCP pools configured on the ASA Firewall, the clints on two different WLAN Networks are getting the IP addresses from the same pool sometimes they get it from the right pool sometimes from the other pool, on the WLAN controll...
Hi,We are using SSL VPN with ASA, we want to save the username and password for connecting to the clients in the SSL VPN client, so the user does not have to type them again to connect to the corporate resources, employees normally use iPhone IOS and...
Hi,I have installed the HSECK9 license and im not sure if it is enabled or not. the output of the show license feature command is as followed.router#sh lic featFeature name Enforcement Evaluation Subscription Enabled RightToUse ipbas...
I have couple ambiguities regarding outdoor mesh solutions, (1) As per the compare page 1510 can only operate in Lightweight mode but there is nothing mentioned about the 1520 behavior, can we operate 1520 in Autonomous mode without using any control...
Two DHCP Pools are configured on the Firewall.
WLAN interfaces are tagged in respective VLANS i have also configured DHCP server under interfaces in WLC and also the DHCP overide option, the clients always get the IP address from the same pool, DHCP...
Giuslar,(1) I have seen the performance sheet earlier, this is my concern if you can see that 2801 is a 48.0 Mbps Router, then why cisco recommends to not exceed 1 T1/E1 Bandwidth, ISR series comprises of a complex data plane may be in a worst case s...
Thanks giuslar and Ganesh,Refereing to table below, 71 mpps mean 23.85 GE Ports full duplex packet per second processing can be achieved right, then how can 4928 can switch @ 96 Gbps.Cisco Catalyst 4900 Series Switch Model Comparison for Fiber Aggreg...
Hi,Do the following steps,Extract From Cisco Documentation, check to see if your image is not corrupted.Press the Mode button while the System LED is still flashing green. Continue pressing the Mode button until the System LED turns briefly amber and...
