Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Greeting,I have a guest vlan 172.16.32.0/24, for internet browsing I want first half of the vlan must by pass proxy and half should pass through from proxy. Below is the configuration.Hardware: Catalyst 6513show run int vlan 12interface Vlan12 des...
Hi,I have ASA5540 running IOS 8.04-K8, users are able to connect VPN over the internet but unable to re-connect VPN when users disconnected abnormally (abnormally means they are not disconnecting VPN manually, while disconnecting manually no problem ...
Hi,I have ASA5540 which is working as a VPN server. I want to redistribute all the connected VPN users into network. I have configured below configuration on ASA5540 but unable to see redistributed network on neighbour routers.router ospf 1router-id ...
Hi,I have implemented "arp inspection" on LAN. We have around thousand users in VLAN 100 (diagram attached) and the reason I have implemented "arp inspection" besides arp spoofing to bound clients/users to not change their ip addresses and machines/m...
Hi,We have two WLC 4402 and around 20 APs model1252G, I have manually distributed between both WLCs.Problem which I am describing is only associated with single user. User have three APs in its surrounding, AP "One" is placed near by 10 feet, AP "Two...
Hi Motaz,Its done, Thank you Motaz for the solution, it worked out perfectly. I set the keepalive to 10, I was thinking the same but was unable to find where would keepalive will be put. I think by default keepalive value is 300 Secs and it did not a...
Hi Anisha,Thank you for your reply, actually we are assigning ip address from Cisco ACS from where user also aunthenticated that is why not using any ip pool. I have tried with ip pool but it did not work out. Currently I am not using ip pool but use...
