Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I have to create a setup where in one check point firewall connects to two different cisco switches. The cisco switches are connected via a trunk.
So from each cisco switch there should be connectivity to the same firewall and if any switch ...
Hi All, I have a requirement where in I have to configure a SSID and there should be only one Password used by Many users. I was thinking of using 802.1x (User on ACS )or WPA2 (local on WLC). Please help with the procedure. Thanks in AdvanceEthe...
Hi vovochka83,
I have similar problem too. We have a checkpoint firewall that I want to connect to two switches and the LAN behind firewall should be learned through OSPF in the cisco switches.
I am thinking that the two switches should run HSRP an...
Thanks for the valuable Information Peter.Ultimatly what I have understood is as follows:1) The SVI Vlan 1 needs to be configured with another vlan say ''Vlan X (SVI and L2 also)''2) VLAN 1 (L2) still has to be there to carry the control trafic on tr...
Hi Guys,I came across this post when I was searching for the best practice to disable Vlan 1 in our Core Network.Almost all things are self explanatory here however i have some doubts and need some suggestions from experts on this forum.following th...
Hi Sirbg can you please let us know how to .... ''You cannot poll the APs directly, but will be able to get AP statistics by polling the WLC '' What configuration is required in the Monitoring Software and WLCs. I am using OPNET VNE Server
1.Check first if u are able to reach Next Hop.2.Get your New IP Pool White Listed with the respective teams including ISP and same from your end.3.Chck if u r going through a proxy , New DNS should be updated.
