Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two questions about how input rate is calculated:On a switch when you do a show int gi x/x, how is the 30 second input/output rate calculated? How often is the switch actually sampling the the input/output rates to come up with the 30 second ...
We have a 10Mb MPLS line connected to an 1841 router, the interface is set up for 100Mb/full. I have a shaping policy set up on the interface, however the provider is claiming that we're bursting to over 10Mb of traffic, can someone please verify th...
I'm having some weird issues with our 3560 that's connected to an MPLS line. The speed of the port plugged into the providers equipment is 100Mb, but we're only allocated 10Mb of bandwidth from them, I tried to police our traffic out of the port usi...
Can someone please verify that my QoS settings are correct? I'm prioritizing VoIP traffic (DSCP 46/COS5) over a 100Mb Layer 2 metro ethernet line, the phones are all Avaya VoIP phones. The reason I'm asking is that the voice quality is terrible and...
I have a few people who we distributed ASA 5505's to and configured vpnclient on them that connect to another ASA at the main site. The setup works fine, all their connectivity seems to work when they initiate it. However, after a while if we need ...
Not sure. Are any of the links overly saturated? Has this EVER worked, or did it just suddenly start acting up now? Any recent iOS upgrades or other changes changes? I would try opening a TAC case. I'm curious about the resolution to this, so if...
What's attached to port 5/8, 1/14 and 1/16? I'm not sure of your topology, but I would assume you want your 6509 to be the root for all those VLANs. Make sure it has a higher priority then the access switches that are attached.
Thanks that makes sense. You said it counts the number of packets...so does it assume some packet size to get the rate or is it sampling packets to get an average size? Or does it also keep track of total bits received and just averages that out?
I don't mean to hijack the thread but I had the exact same issue last week, have a floating static route took over when an MPLS line went down, when it came back up the static route was still in effect. I fixed it by removing the static route and re...
