Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,Having Cisco DNAC ,try to provision new switch with lan automation. Started automation and switch is discovered,but in middle pressed on switch console showing error stopped pnpa.Provision stucked in 60 % got the ip address for switch waited...
While creating acl for connecting to checkpoint vpn, already enabled ports tcp 443,500,udp 259,500,2746,4500 ESP,AH,SKIP. But still got stuck in 47 % while connecting from client laptop on checkpoint vpn as we allowed URL cvpn.****.comAs there is no ...
2 switches with 48 and 24 ports placed in stack.As a new requirement the 24 port poe switch replaced with 48 port switch. But after giving stack connectivity and provisioning new 48 port switch, we are able to access only first 24 ports of new switch...
After changing the interface ip and default gateway ip cisco router 4331, device got registered in new ip and its reachable. But the PRI's are getting registered to secondary subscriber, which is hosted in different location.Whether I need to check a...
Hi all,Deleted device from pnp and newly do lan automation and device was discovered and provisioned, but add as edge node and later do the provisioning ,provision is success but later the error showing as credentials failure, even try to validate as...
