Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Something odd has been happening in my Cisco Business Wi-Fi deployment built on Cisco CBX150AX access points.Occasionally (not often), one of the APs reboots for an unknown reason. Historically this was mostly harmless — at worst, someone in a Google...
Hi everyone,I’m having the following issue with my CBW150AX access points:Recently, I changed the Channel Width setting from 20MHz to Best. After that, 9 out of 11 APs successfully switched to 80MHz, as expected. However, 2 APs remain stuck on 20MHz,...
Hi guys!I have 9 AP i network. Ip addresses are below in screen shot.But ipaddress of ciscobisiness.cisco is other - 192.168.11.45So i can't get access to Web admin panel with any of AP ip addresses from list above. I can see ip address of ciscobisne...
Hi everyone.I tried to do software update on my wi-fi network. I have set of 8 primary AP without mesh.Every time when pre-downloading for first AP was complete it show error "Invalid tarfile or extraction"Now I have 10.2.2.0 version.I tried to load ...
Thank you for the response.That’s exactly the issue: the controller that rebooted never becomes the Primary AP on its side, but at the same time it duplicates the same MAC address as the Primary AP. This behavior can persist for days. If nothing is d...
Hi everyone again,So, it turns out the issue wasn't with the APs themselves — but with how channels are automatically distributed between all APs in the network by default.There aren’t that many non-overlapping channels available, and using 80 MHz ta...
As resume:I can not find this in documentation.But i found this video explain tis feature:https://www.youtube.com/watch?v=IO17RhUkiJMThis screenshot shows where is this setting:
