Suppose I have a set of 5 ports on a switch which are all teamed and allow traffic on vLAN5 I want to allow traffic on vLAN6 on the group of teamed ports. Can this change be made without any downtime? In other words, can the change be made in such ...
Does anyone know where you can obtain some good visio stencils for cisco equipment like routers, switches, gateways, cables, ports, etc. The default ones in Visio leave much to be desired. Any input appreciated - thanks.
I have a switch which will connect to a physical server used in virtualization. This means that virtual machines with IP addresses on multiple subnets will be sending layer 2 frames to this switch. However, in attempting to minimize the number of N...
Hello,We have two areas of the datacenter which are phyically separated (perhaps 250 meters). Up until now these areas have been on two different subnets. However, now we need to start moving some servers from the one area to the other without chan...
OK thanks for the input. In this case I'm not sure if that would workbecause this does need to be a long term solution - the both areas of thedatacenter need to be able to permanently host systems on the subnet thatis currently only accessible in on...
