Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I know I can setup three types of SSL VPN's:Clientless - through the browserThin Client - Java based with port forwardingSSL VPN Client - Tunnel Mode with the client software.I'm looking for a way to do a thin client that doesn't require port forwar...
Hello Everyone,I'm trying to scheme a way to preserve client IP addresses on a CSS 11501 that is running in a one armed configuration.The CSS was added before we needed to load balance and the site(s) which it serves are in production and really can'...
It appears this has been brought up before, but it was never resolved.Currently I have an ASA 5510 connected to our distribution layer using an IP address in a subnet protected with HSRP. If one of the two dist layer devices go down, the firewall is...
Hello,I have sort of an interesting problem, that probably has an easy fix. I've ran into a continuous BGP convergence problem on the cores of the network I administer every time I bring up both of our Savvis connections (we have a single OC-12 and ...
I thought this would be very straight forward, but I guess not.Currently the network I manage consists of 3 main sections with two 6500's for the dist layer, in each section, which in turn, have layer 3 connections to a set of 6500's acting as the co...
I guess from my own research there are only two ways to do this:1. Use redundant 5520's in an active/standby configuration since VPN's can't be utilized in active/active config2. Use HSRP on the core of our network. Use layer 2 connections on the si...
The problem we are seeing is that the network never fully converges.The RIB continuously changes who is the best route for some, but not all networks.From the research I've done so far, there are a few things that I could also try.1. Strip the MEDs a...
I'm actually having the same issue, but from a 2651 to a syslog server behind an ASA 5505.I can connect to servers on either side and ping them without a problem, but when I attempt to connect from the router to the syslog server, even ping it, I get...
Thanks Glen for your response.Below is the output from my lab setup. I have verified the configuration is exactly the same on either side, both in the lab and in my production network.Name: Gi0/1Switchport: EnabledAdministrative Mode: trunkOperation...
