Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good Day Support Team around the world,Having started recently tests with 802.1x in a lab environment, I noticed a strange behavior related to authentication. First let me provide you with the network components I used.supplicant: ...
Hi,I have already set up a lab comprising of 1x2950-24 switch, 2x3750-24T in stack mode and 2x MS Domain Controller with AD 2008 Servers and NPS enabled (Domain level 2008). I use NPS as a Radius Server. I am trying to test the 802.1x framework in ...
Hi everyone,I have an 2811 Internet router with ADSL uplink and there is a need to configure subinterfaces to the main FastEthernet interface pointing the internal LAN and is connected to a layer 2 switch. So my question is where I have to configure ...
Hi I have a 6509-E chassis with a FWSM [FWSM Firewall Version 3.2(5) and I have enabled NAT control. In configuration file there are the following commands:nat (inside) 1 10.10.0.0 255.255.0.0 tcp 0 300nat (inside) 5 10.10.10.5 255.255.255.255 tcp 0 ...
Hi,I am working in a DMVPN environment with two HUB and 25 Spoke routers. There are mGRE tunnels everywhere with the same basic configuration. There are also attached in WAN Serial & ADSL interfaces Extended Access Lists permitting only the esp and I...
Hi Josef,You are absolutely right!!! Well done pal. Check below the output from my lab stack switch:************************************************************************SW-LAB#sh system mtu System MTU size is 1504 bytesSystem Jumbo MTU size is 90...
Thank you for your responses.However I tried to change the supplicant configuration for User Authentication Mode only but I had the same results.Please keep in mind that with the same supplicant either in User/MachineorUser/Machine authentication mod...
Hi,1452 because PPPoE truncates the Ethernet maximum transmission unit (MTU) 1492 and if you consider the IP header (20 bytes &) and TCP header (20 bytes) then finally we have 1452. http://www.cisco.com/en/US/docs/ios/12_2sb/12_2sba/feature/guide/sb_...
These two interfaces have not the same security level.The bug CSCta74788 is for the same security traffic between interfaces. The configuration is exactly these lines and nothing more. It seems that FWSM wants a more specific NAT entry to work for t...
God bless you Mike!Great job!!!!!!!!!!!!!!!!!!!!!!This is the answer I was looking for, all this time. I was 100% sure that something goes wrong.Anyway, I will configure all Tunnel interfaces with the recommended values asap.Mary, I have no words. Yo...
