Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Below is the VPC Configuration done on switch this switches are not in production yet But wanted tpoo know the type2 consistency issue may effect traffic. Attach is both switch Vpc config
We have FortiGate WLC for wireless user .
After posture scanning if the user is non-compliant we are unable to restrict the access user is getting full access.
We tried from ISE to Push ACL still the restriction is not working.
Wireless user connecti...
My posture condition for windows device are as follows:-
Windows Patch min 10.X
Windows Fw - remediation if not enable enable it
VPN check.
My windows system is running on version 11 24H2
Facing isssue as follows:-
Windows patch check failed
Window...
Need MAC Book wireless device authentication using mab for SSID via ise server and the same ssid we will use for dot1x auth also.
We are using Meraki cloud for wireless
Is there any reference link to implement this solution.
We have configure AD as identity source on ISE for authentication .
Then how we can call group from fortigate is it will initiate authentication again?
We are using a 9300L switches for stacking but the there are 2 network rack .
There is 3 switch in one rack and 2 switch in other rack.
We have 3M stack cable but as per rack position it will not sufficient for stacking.
So can we use DAC Cable for v...
Hi Marce
Thanks for the reply.
We are looking solution for fortigate firewall and fortiap .
As after posture check the compliant endpoint should assign the compliant profile to endpoint it was not working as the COA acknowledge received from fortigat...
