Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys.I have a problem with one router with IOS 15.0(1r)M15. The problem is like this: This router is learning the same route from 2 protocols:OSPF directly(AD 110) and from EIGRP redistributed (D EX AD 170). So the router is installing in the rout...
Hi,I would like to ask some questions related to the following output listed below.1. Why does sh ip eigrp topology lists 1 successor for 4.4.4.0 network when there are actually 2 (even a feasable successor). Variance 2 is used.2. When can I actually...
If you make an alias for your computer's MAC address, the Cisco switch will learn the avertised MAC and in parenthesis you will also see the BIA MAC Address. How does it detect the BIA Address?
Hello guys!I am trying to set up a routing policy that is dependent on tracking an IP that is not a next hop but a far IP, from the Internet. In the attached topology Internet router has an ip of 8.8.8.8I want to implement on the Client the following...
Hi guys!I am practicing some route-maps and I came across an issue I don't quite get. Please see the below topologyMy intention is to create a policy on Aggie so that when I have to route a packet destined to 192.168.13.1 to go right to Ace because w...
You are right. I was confusing it with the output of "sh int". Rockie mistake Router#sh int f0/0 FastEthernet0/0 is up, line protocol is up Hardware is Gt96k FE, address is c000.09d0.0000 (bia c000.09d0.0000) Internet address is 12.12.12.1/24 M...
