Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have 2 L2 link that access to 2 different site, and that 2 site can access site D.What is the best way to configure the 2 L2 link and not cause loop?Can I configure it etherchannel active passive or any alternate way?
Hi, I am creating a L2 vlan for heartbeat usage purpose.However, the 2 server node NIC cannot ping each other. Any advise on this? Server 1 > 192.168.1.2 255.255.255.0Server 2> 192.168.1.3 255.255.255.0 int vlan 110no ip address int gi0/29switchport...
Hi,Is there anyone can advise the Avaya IP 9608 phone switch port configuration with Cisco switch?Can I configure it as below:switchport access vlan XXswitchport mode accessswitchport voice vlan XXsrr-queue bandwidth share 10 10 60 20priority-queue o...
If I have existing etherport channel switch uplink, and I configure lacp will there any impact?if lacp sys-id already 32768, do I need configure lacp system-priority value still?sh lacp sys-id32768, 1cdf.0ffd.d180How do I determine lacp system-priori...
Hi,Site A (C4500) and Site B (C3750), running HRSP VLAN SPAN.Site B Config>spanning-tree mode rapid-pvstspanning-tree extend system-idspanning-tree vlan 10-90 priority 28672 I have tried Flex Link on 2 L2 link between Site A and Site B, the link seem...
Hello,The new interconnected link is at C site as below diagram.Any advise to on the best way configure C new link, and the site A and site B have VLAN span across 2 site A and B.
Hello,Thanks. I need your advise when looking Flex Link.If the configuration without the below config, the backup line will not fail back to active link in the event active line back to service?switchport backup interface gigabitethernet0/X preemptio...
