Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone successfully run the dot1q tunneling on Cat4500 with Sup7L-E? I tried that on IOS XE 3.3 and newest 3.4.It is in feature navigator but i am not able to connect two access switching using trunk - only native vlan is translated. Apparently S...
I am trying to find a solution to load balance traffic in DMVPN ( 200+ branches )solution where branch with 2800 router has two ISP connections that connects to two HUB routers ASR 1k. I want to achieve that some applications uses one WAN link and al...
I am wondering is it possible to accomplish following scenario.I want to authenticate users connecting to my network using 802.1x based on Active Directory, but to be able to put users from external database (AD) to different Vlans based on some spec...
Hi Guys,I am having problems with CPU load on 2811 with AIM-VPN-II. There is a GRE+IPSec over E3 WAN link and the authentication is done using RSA, but even that there is around 10Mb/s of traffic I have a 70 - 85%.I also have another WAN link with ro...
Hello,I am searching for solution on how to do a source and destination NAT on PIX 506E.I attach the drawing. Let's say I have a web server inside. I have created a destination NAT, that traffic which goes on 200.200.200.200 is nat'ed on 192.168.1.2....
Yes, it should work, but it doesn't. I did the config with documentation. Moreover i have the same config on Cat3750x, Cat3560 and it works just fine. TAC is trying to resolvei the problem for 1,5 week already and still nothing.It must be something w...
Thanks for your answer. Its tricky, but might work. Could you please share your config for hub and one of the spokes.Is your design and configuration works that traffic for DATA goes out ISP1 to HUB1 and gets back to spoke through the same path?
Nevermind I already managed that Under Windows Database Mapping, define group in AD and them map them to different Groups and assign them vlans.Tested and it works just fine
Hi,It seems that it works, but after applying it, the other nat global-1 that hide all local networks to the internet is not working:nat (outside) 2 access-list source-nat outsideglobal (inside) 2 interface access-list source-nat permit ip any host 2...
It works, I have tested that in lab!!! I have been searching for solution for the whole day and found nothing, but now as I look at your config it is clear Thanks!
