Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have had a UC520 in the field at my office for 10+ years, running 12.4(11r)XW3. ATT has been providing their SIP connection via fiber and a Cisco router to UC, with the UC hitting a remote SIP server, and things have been working great. They wish t...
The performance spec for the C11111-8p lists the router at 350meg . Is that the maximum over VPN, applications, or simple routed NAT. Our environment is primarily residential, with some small business - VPN performance isn't super critical, as it is...
I have a HP printer on my Office VLAN ( 192.168.160.190) that I would like to create a virtual IP on my House VLAN at 192.168.150.190, to allow printing from the less secure House network to Office network. I need assistance with setting up the netw...
I have done 40-50 deployments using CT-2504s and 6-15 access points, mainly in high end residential environments. I now have a commercial job, that will have 18 APs ( 17x 2800 series, and 1x 1560 Outdoor).. The client is very concerned about wireles...
I have successfully rolled out approx 600 800, 1900, and ASA's into residential environments.. In general we put the 881 into residences, and reliably hit the high 80s, low 90s on speedtest.net .... with the 1921 and ASAs we are able to hit the exi...
This is partially an exercise as well, so I wish to keep the printer on the Office side, plus it simplifies things like AirPrint etc. that I can initiate from my Office Wifi.That said a little more nudge in the right direction for the virtual IP setu...
I have a few months before the project is going live, so if it can be done, I can figure out how to do it... However, does the 3850 as a WLC have all of the features that I am used to on the 2504?
i.e. a) ability to do broadcast forwarding and tunin...
I went onsite and tweaked the system a bit, but in terms of doing a parallel hunt group, is there any way of doing that with a intercom paging and not just ringing everybody? It seems as if a shared extension is the more likely solution, but how doe...
Paolo, thank you for the link... I skimmed through that section but I don't see anything that jumps out at me with respect to answering a one way page by picking up handset.i.e. Use a one way paging group, have the users listen to the page, and if so...
