Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So we just noticed our max throughput on one of our network stacks is only getting around 450mbps when doing speed tests. When I connected to our other stacks, I get around 950mbps when doing a speed test. This is the only thing I noticed that is d...
Current FW: c2960x-universalk9-mz.150-2.EX5.binUpgrading to: c2960x-universalk9-mz.152-7.E7.binI copied the new FW to all the switches. I then configured them to all use the new firmware (boot system switch all flash:/c2960x-universalk9-mz.152-7.E...
Is there anything else that needs to be done after editing fileUpload.cgi ? After saving, I tried to upload the MacOS package that was over 100mb, but I'm still getting an error.
I know this is an old message, I was wondering what options can be done for a switch that is NTP Master for all your other switches. I found this: https://community.cisco.com/t5/network-management/ntp-allow-mode-control/td-p/4596164So I went with ...
Thank you for your explanation. I have successfully upgraded all the stacks in our environment. Hopefully your information will be helpful to others who try to do things wrong like me. LOL.
