Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Currently, client devices from a partner network are communicating with a server located in our data center.These devices are configured to communicate with the server using the destination IP address 172.17.35.10.However, the actual server IP has re...
Hello,I'm trying to register CRC counters on our NMS, but I haven't been able to find the appropriate CRC OID values for C9K, N3K, and N9K series switches.If anyone has information about the correct CRC OIDs, I would greatly appreciate your help.Than...
Hello,I have a question regarding interface configuration.Should PortFast be enabled on the interface that connects to a firewall?If it should be enabled, could you please explain why it is necessary?And if it's not needed, I would appreciate it if y...
Hello,I'm planning a network setup as shown in the diagram, where SW1-SW2 and SW3-SW4 are configured using Stackwise.In this setup, I intend to connect SW1 to SW3 and SW2 to SW4, and configure MEC (Multichassis EtherChannel) accordingly.I'd like to a...
We are planning to replace two Cisco Catalyst C9300 switches that are currently configured with HSRP.Could you please recommend the best approach to perform the replacement while minimizing service downtime?Any detailed guidance or best practices wou...
