Inquiry About MEC Configuration with Stackwise Setup

[qkrrudgh036]

Hello,
I'm planning a network setup as shown in the diagram, where SW1-SW2 and SW3-SW4 are configured using Stackwise.
In this setup, I intend to connect SW1 to SW3 and SW2 to SW4, and configure MEC (Multichassis EtherChannel) accordingly.
I'd like to ask if this configuration is supported and will work as intended.

Thank you in advance.

[Joseph W. Doherty]

Believe both Stackwise or Stackwise Virtual would support.

As to working as intended, what's intended?  (That's not a frivolous question.)

[qkrrudgh036]

Oh, it's nothing else — I just wanted to ask if MEC configuration is possible in this setup, where SW1 is connected to SW3 and SW2 is connected to SW4

[Joseph W. Doherty]

---

@qkrrudgh036 wrote:

Oh, it's nothing else — I just wanted to ask if MEC configuration is possible in this setup, where SW1 is connected to SW3 and SW2 is connected to SW4

---

Ok, then again, it should be for Stackwise (or Stackwise Virtual).

Just curious, are you new to this technology, or is there some reason you thought it wouldn't work?