Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am working on a NAT configuration for a SDWAN Viptela install similar to below ip nat pool 123interface natpool1ip address 10.123.123.0 /24natstatic source-ip 10.123.200.30 translate-ip 10.123.123.30 outsidethis is a working installation the route...
hellois it possible to change the configuration for OMP ? for example disable redistribution of static routes ? I cannot find a way to do this on the templates
hello all I have deployed a C8000V router on an existing SDWAN platformusing the Real Time option under Monitor I can see the device has OMP peering & the other devices are receiving this site TLOC & this site is receiving TLOC info from other site...
hello all I have not been able to attach a Viptela device config to a virtual device in Azure As a workaround I wanted to configure features using CLIfor example create a service VPN 2configure NAT on the service VPN Q does the community know if this...
helloI have onboarded a c8000v into vManage the device status is reachable when I go to through the process of pushing a device template the process fails after scheduling this initial device template has VPN0 +Eth , System info when I do a comparis...
many thanks please see below for the NAT pool attached using the device templateinterface natpool1ip address 10.237.123.0/25natstatic source-ip 10.233.123.30 translate-ip 10.237.123.13 outsideAs I understand the syntax -- 10.233.123.30 is a source I...
many thanks for this explanation reference the VSmart config please see below from the controller how can this work with the NAT pool not on the configuration of the vSmart controller ?the config refers to a NAT pool 1 that does not appear in the Vs...
hello another question relating to the NAT setup please see below from the controller the config refers to a NAT pool 1 that does not appear in the Vsmart config sequence 20matchdestination-ip 10.237.123.0/25!action acceptnat pool 1!Q how can this w...
I cannot post the full config because of security reasons - what I can say is that when I sho ip route in Realtime view I cannot see any hosts in the inside network on the VPNthank you for your help
