I'm sure you went ahead and moved the CTI Ports into another CSS, but I would like to point out that you could have also resolved this by adding the CTI Port DNs (either individually, or by using an appropriate Mask) as translation patterns into Par...
The very first thing I did, before posting, was to upgrade the firmware. The did not help.I am posting the mht file as you requested. This is becoming urgent, as the system had to go live without any redundancy,so I need to resolve this without usi...
Alberto,I have tried to setup the manual SRV on the SPA504 according to your document and it will not register if I use the SRV= format no matter what I try to do with it. It will only register if I use a single IP address or DNS name. I cannot acc...
There is a patch to be applied to Co-Resident IPCC express installations for this problem. If you go to the Cisco Download section for CRA: http://www.cisco.com/cgi-bin/tablebuild.pl/crs35You will find this patch -- that should solve your problem.
We are successfully using a Brooktrout analog fax card connected to FXS ports with FaxServe rather than RightFax. This will not work dependably with ATA's in my experience. Also, you need to configure Fax Relay via H.323 (not MGCP) for this to work...