Hello,I have a mgcp gateway deployed with CUCM 11.0. The issue is that outbound calls are not working. I will appreciate help on how to resolve this. Kindly find below and attached the output of "show viop ccapi inout" !!!!!!SRST-HQ#debug voip ccap...
Hello Team,
I have a customer who has a conference phone 7937G. The issue here is that the room is large that the audio from the phone is always not audible enough for the meeting participants sitting at the extreme parts of the room to hear remote m...
I am working on Telepresence Video design for 5 locations and Skype for Business interoperability is a requirement. I have made provision for CUCM and Meeting server (Hardware and Software/Lics) My questions are: 1) Is a Call Control (CUCM or V...
I am building a telephony platform for use by a call centre and I have chosen to use a UC 560 FXO Model router for Local call routing and SIP trunk to a GSM gateway for Inbound and outbound calls. Hence my questions:1)Does the UC 560 FXO model router...
Hello Everyone,I deployed UC520 with 7937 conference phone. The conference phone can make both internal and external calls. It can also conference internal numbers (ie the IP phones).The challange is that it cannot conference external numbers (like G...
Thanks for the Response,Since this has been working for years and there was no configuration changes but only stopped after power outage, is there a way i can prove to the PSTN Provider that the Gateway is sending out the call to them and that it is ...
Thanks for responding, Kindly see the DNA below."debug isdn q931" and "debug voice translation " does not show any output <?xml version="1.0" standalone="yes" ?><DigitAnalysisResult><ResultsSummary><CallingPartyInfo><CallingParty><![CDATA[2717407]]>...
Thanks for the response. Note that debug isdn q931 does not show any output when i make outbound call. I can only get output from debug isdn q931 when i make inbound call.I also could not get output for "debug voice ccapi ind 1"See below the output ...
@Nick Halbert-Lillyman wrote:Assuming this is an on-prem deployment, you need CUCM or VCS as your call control, as well as CMS to provide the interoperability. Shared Multiparty Starter kits aren't required, but will give you some cheap TMS licenses ...
.jpg "Hall of Fame Cisco Employee"){kind=icon}
