I am trying to decide the best way to setup a multipath network.  Any suggestions are appreciated:I want to route all traffic destined for the Internet from SiteA on PathBSiteA 10.0.0.0 to SiteB 172.16.0.0 on PathBSiteA 10.0.1.0 to SiteB 172.16.0.0 o...

I am trying to figure out how to leverage two high speed circuits we have.One of the circuits is 100Mb and the other is 45Mb. We use OSPF for our routing protocol. If you reference the attached file, I am trying to get the 192.168.5.0 /24 address t...

I have several switches where I am getting incrementing hold queue drops to the tune of several thousand over a 5 minute period. These occur consistently throughout the day.However these Hold Queue Drops (IQD) are only occurring on the VLAN201 inter...

I am trying to make 2 2620's connect with MLPPP. The problem I am having is that 1 of the WIC interfaces goes into alarm mode after boot up.When I boot up the router the second WIC will go into alarm mode and not pass traffic. If I then shut down t...

Does anyone have an example configuration for connecting a Valcom 2006A multizone paging device to a FXO port? I want to be able to dial 14 and get the paging system. Thanks!Matthew Pickensmpickens@emergeinteractive.com