Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys recently I have an issue. C9117AXI-H power level can not set to datasheet's guaranteed value.Is it a configuration issue? Currently using C9800-CL with it. When I use EWC mode + power level 1, it can be set to 25dBm. But I compared, when the ...
Hi guys I want to buy a used C1111X-8P router, but when I check its download page it says entitlement required.Can I just fill in the router's S/N to get permission of downloading?
Hi guys! I want to purchase a used C1111X-8P router as my home PPPoE router (don't ask me why lol just because I like Cisco products)And I have a small question about this IPv4 forwarding throughtput (IMIX). Does it mean that it will handle 1673Mbps ...
Hey guys I want to use a single C9117AX access point for home use. I figured all things except licensing. Does it require any license to run EWC to just manage AP itself?Much appreciate if someone answer my question!
could someone check my configuraiton? That'd be much appreciated!I tried using CSR1KV and C8000v for home use with letting it act as PPPoE client and NAT gateway but with fail.I almost searched for the whole internet for a resolution....When I use Op...
Hi bro and I want to thank you again.I tried using EWC mode and found it will cause the AP's speed and signal both very bad.( Not sure if it's my configuration issue) And I built a C9800-CL VM and configured my AP to FlexConnect mode. It splashhhhhed...
yes bro I need it work as PPPoE client. Want to use it as my gateway of my home.I will try again or buy a used C1111X-8P cuz I like hardware product of Cisco....Thanks again!
