Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi experts ,we have FMC managing our FTD's and version is 7.5 Recently few users had some issues connecting via the VPN while they are working from home, and i was struggling to troubleshoot the issue from FMC as haven't used FMC much in recent year...
Hi All,I am preparing for ISE upgrade from current version 3.3 patch 8 to patch 12 .Prior to upgrading, I did the system and operational backups and also exported and saved the system certs.1. Do I need to export all trusted certs as well and save th...
Hi ,I was asked to disable 802.1X for a few specific ports, and all I had to do was under the switchport: remove access-session port control-auto command.But recently, there was an incident across the entire branch where users were not authenticated ...
Hi All,We have Catalyst 9300 stack switches and have been asked to conduct an audit to see which ports have actually been used in the last 3 months.Which CLI command would you suggest to get some accurate stats ?I have tried show interface link, show...
Hi All,I have the following issue, and it would be great if you could provide some ideas on this. we have voice handsets and currently connecting to 3rd party switch --->checkpoint fw --- connecting to LAN switch (sw2 Trusted network).Recently we are...
@Gagandeep Singh Thanks. Finally, regarding no dot1x system-auth-control to disable dot1x switch-wide, will it strip all dot1x configuration on the switch, or just disable it and remove the syntax?if I want to enable the dot1x again, adding dot1x sy...
@Gagandeep Singh Just a quick question: if we use no dot1x pae authenticator, will it disable MAB as well?And let's say we disable switch-wide dot1x , (no dot1x system-auth-control) , will this remove all the dot1x configuration from the switch or if...
