Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to setup (2) Exchance 2010 CAS/HUB Server on Content switch with the following ports configured. 587. 25. 135, port 6005 range 65535.Is there anything special I need to do. Below is what I have setupservice EX10HTC1-1 ip address x.x.x.x...
I recently received these routers and after the first reboot I changed the user id and password so it does not lock out...After configuring my routers for installation, upon bootup I am getting this message scroll down my screenmonitor: command "Plea...
I am in the process of Migration all servers from our Content switch to CIsco ACE4710.one content has this line itemadvanced-balance sticky-srcipWhat would be similar option in ACE.?Thanks for any help on this.Mehdi
I am trying to setup 2 ACE in a FT mode. While both are active, I am all goodMy questions are:1) If I unplug the primary ACE Network cable, I loose connection to my HTTP servers (via VIP address) and my ping to the VIP failes, eventhough the second...
One requirement based on my Exchange Admin person is the requirement for Port range of 6005 through 65535 which I have created for the services. But that is not an option in the content rule...See below for my configservice EX10HTC1-1B ip addre...
I hope below displys correctly. Baically I access the VIP address that is defined on the CSS...The CSS, sprays between two hosts.Host A Host B! !! !! !! !Server Switch!!!!!!<-----------------------------...
