Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Any idea how to resolve this? I can't seem to ssh into the router, and consoling in yields the following error message.Running cat4500e-entservicesk9-mz.151-1.SG.bin on a 4948. *Dec 31 17:32:39 PST: SSH2 0: input: padlength 6 bytes*Dec 31 17:32:39 P...
Folks, Any idea how to remove this from the config? router isis backbone set-overload-bit on-startup 180 is-type level-2-only ! ISIS network number should be encoded with 0-padded loopback IP ! example: ! example: net 49.0001.1921.2022.0222.00 I tri...
Folks, I am having an issue with routing to a certain prefix within a vrf. I cannot seem to route to it from devices 'behind' the PE, however the PE seems to know how to get to it. Let me illustrate with a few traceroutes. Hoping someone can help. Pl...
Is there was a way to search on a route reflector and find all prefixes that were tagged with a certain community? I am finding it a little tedeious to check each prefix with "sho ip bgp vpnv4 all x.x.x.x" and find the extended communities.
Peter,I 'think' you are spot on and my test did fail with the traceroute. I am going to investigate the 'router owning the bad prefix' further and report back on this forum. Also, thank you for jogging my memory on the MPLS traceroute piece!Thank y...
Peter,No apologies necessary, I am very grateful for your help thus far. I think the direction you have given me above was exactly what I needed. The subtle difference between using a Standard and Expanded extendcomm list was HUGE. Thank you so much...
