Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
INE foundation lab 1 - DMVPN eigrp keeps flappingHello, i am working through foundation lab 1 and I got to the DMVPN phase 3 portion and I got stuck. R1 is the hub, R5, R9 and R10 are the spokes. When I enter the solution on the routers, the link fr...
We are troubleshooting an intercom device where audio works but video no longer does. Devices uses POE and is on a 3650We've done a ton of troubleshooting and even rebooted the switch. The intercom works fine when plugged into a different switch. Ca...
Hello , i have a lab environment at home and i am running csr1000v's on an ESXi host and i have them connected to a physical switch, they see each other via CDP so that isn't a problem.From R1 (CSR1000v) i have a sub interface g2.10 with dot1q 10 goi...
I was wondering if VIRL has a trial version you could use before you buy it. I hear GNS3 is better and it is free. I wouldn't mind using VIRL but Id like to play with it first before cranking out $200 bucks.
Any ideas? Thanks.
Hello,
Recently did a "show cdp neighbor detail " on a switch and on the other side was a ip for an SVI that was used for voice, not the actual management ip. I was surprised to see that since it has its own management interface vlan with an ip. I c...
I have read at least one other thread with this specific issue when it comes to connecting physical hardware to the CSR1000v's.Any ideas? I posted the configs hope that helps.
