Hi folks,   I have GNS3 configured on my PC which works wonderfully after 3 days headscratching What I would like to do is, from the CLI screen, when I issue a command say 'show ip route' , I want to scrape the output of the command and save it to m...

Hi, Lab Scenario:R2, R5 & R6 are connected in a Partial Mesh F/R topology with a F/R switch at the centre.R2 is multi-point sub-int whereas R5 & R6 are using physical ints.EIGRP is configured on each router advertising network 150.50.0.0 via 'netwo...

Hi, As part of a Lab setup I have 2 routers (R7 & R8) connected via serial (2Mbs). Each router then connects to switch2 (10Mbs). R8 is an ASBR as I am redistributing the connected network between R8 and the switch. I redistribute this network into O...

Hi, I have a Lab Scenario as follows:Two routers R2 & R4 are connected to a F/R cloud via Area 246. They are also connected to each other via Ethernet in Area 0. I have two loopbacks configured on R2 (2.2.2.2) and on R4 (4.4.4.4) in area 246 also.T...

I have a router connected to a 3550 switch. The router is in vlan 55. I want to limit communication on vlan 55 to the mac addresses of the routers E0 int (0000.0c0a.38c4) and the mac address of the switch (000d.29ce.0180).I have the following config:...