Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, i had a problem that was discussed a lot i think.I have to migrate our active/standby firewall configuration in one single firewall and dual ISP configuration.My question is about the Anyconnect SSLVPN.Can someone give me an example about the...
Hi all,i have a main site with a x.x.x.x address with an active dhcp, all are behind an ASA 5512-x.I have a branch office with y.y.y.y address with an active dhcp and 3 vlan with ip-helper active.
I setup a site-to-site VPN with IKE2 and preshared, a...
Hi all,
i have a simple question, it's possible to send a particular syslog message via email using Ciscoprime ?
I want to send the port flapping syslog message to an email recipient.
Best Regards
Massimo Riboli
Hi all,
i've an installation of Cisco Prime 3.0 update 2.
Yesterday i've downloaded the device pack 3, but when i try to install update a pop-up appear that i'm not able to install it "unsigned updates are not allowed because security requirement" (...
Hi Pablo,
sorry for the delay of the response, but the client is hard to convince about the maintenance Windows...
So i'm glad to communicate that you solution works like a charm.
Many, many thanks.
Best Regards
Massimo Riboli
i don't know if i have posted that in the branch site i have a DHCP with 3 VLAN and ip-helper active.
what i can see if that i activate the NAT that enable hairpinning
nat (INSIDE,OUTSIDE) source static NETWORK_OBJ_10.100.1.0_24 NETWORK_OBJ_10.10...
Hi Pablo,
sorry for the delay...
The configuration on both ASA are little dirty, there are more than one crypromap access list, but only one is used..
So i use the command sh crypto ipsec sa on both appliance, this is the main site:
interface: outsi...
