Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone, i made a trunkk between CUCM and VCS, calls from VCS registered endpoints are OK, calls from CUCM registered endpoints are not workingMX200 registered on VCS, EX60 registered on VCS, TANDBERG 1700 registered on VCS and DX80 registered on...
Hi everyone, i made a trunkk between CUCM and VCS, calls from VCS registered endpoints are OK, calls from CUCM registered endpoints are not workingMX200 registered on VCS, EX60 registered on VCS, TANDBERG 1700 registered on VCS and DX80 registered on...
I have a weird problem with my switches, when i connect the NVR and the IP Cameras to any Cisco 6500 switch, the NVR never detect the IP Cameras
and when i connect them to any cisco 4500 switch, the NVR detects the IP Cameras immediately
I tried thi...
i have a problem with my firesite4000 server, i can't access the ips server and when i opened the CIMC i found that the HDD is unconfigured
is that mean i don't have the IPS on the disk and no license?
Hi guys, i need your help, i made a big mistake, i reset the MCU configuration and after restarting the MCU i lost the product or feature key
i need to know how can i get new one
i don't have contract with Cisco
i bought the MCU from Ebay!!!!!!!
I tried to make a call but i always got this message: "could not place a call to H323:700"
calls from cucm SIP endpoints to vcs H323 endpoints are OK
calls from vcs H323 endpoints to cucm SIP endpoints gives the message: "could not place a call to H3...
Thanks Everyone for your help
i was in hurry and it was urgent that's why i duplicate the thread
the Transform on VCS solve the problem
i made the pattern string : (.*)@(10\.10\.30\.172)((:|;).*)
and it works now
