Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can someone explain to me the way that 'add service' and 'add destination service' commands work when groups are configured. The config guide wasn't too clear on this point assuming a wider knowledge of this subject I think. We have 3 content rules c...
We have an issue with a device on a route receiving TCP resets whenever a connection is attempted. This route goes through a third party. We have removed all blocks on our part of the network. My question is, how do access-lists deal with denied pack...
I am implementing a basic rate ISDN back-up. The problem I have is that one of the legacy routers we are replacing has a basic rate feed into a mux which then takes it out through a primary rate access.The switch type is primary-net5 (for UK) which c...
Can anyone help me out here. I have an old Cat 2900 that has a 9 pin Serial port for the console instead of the standard RJ-45. I have tried various cable configurations but cannot console in. I have searched through the website here but cannot find ...
We have an issue with passing smtp through a vpn tunnel between a Symantec Raptor firewall and a PIX 525. We have connectivity between subnets as we can ping.Furthermore we can telnet on port 25 in one direction with no problems but when we telnet fr...
We are using a WIC-1B-S/T for the basic rate. I figured that I would have to recommend a new basic rate line but thought Iwould throw this one out to see if there was a workaround. Gotta try these things. The Primary rate is carrying other traffic an...
For Layer 3 routing between VLANS you need to specify a VTP domain. At least 1 of your switches must be a VTP server any others can be clients unless they don't actually participate in the VLAN infrastructure then you can set them as transparent e.g....
