Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,In CME on an outgoing dial peer can somebody please explain the difference betweenDestination-pattern TAndDestination-Pattern .TAlso, are all digits sent to the Telco on both of these destination patterns?ThanksChrisSent from Cisco Technical Suppo...
Hi,We have remote sites that use VOIP over a site to site VPN into a central ASA.I have set up QoS on the ASA for these VPN Links but does the switchport that connects to the ASA on our Internal Switch also need Qos configured?The switchport that con...
Hi,We a remote user set up with a Cisco 877W that connects into a ASA5510 using EasyVPN (remote user has dynamic external IP)The home setup also has a physical Cisco VOIP phone that connects into a Call Manager Express system over the VPN.The home us...
Hi,I wish to extend Wireless access in our office and have a AP1131AG access point connected to a 1801 Router on port FastEthernet2,The 1801 has several VLANs configured, Public Internet access is on VLAN7.The access point is still on the default Nat...
Hi,I'm looking to set up VLANs on a Cisco 877w (Base Image), AFAIK this should support 10 Wireless VLANs and 2 Wired VLANSI have set up the Native VLAN as a Bridge and incorporates 3 of the switchports and the DOT11Radio0.1 Interface and works fine.I...
I ended up soldering a 150 ohm 0603 resistor to my 5506, I can now get into the rommon but it will not boot from the image (either flash or usb) and displays the error "No kernel found to launch." It is also showing some strange messages on boot wher...
We have a 5506 V02 that has just been bricked because of this issue, what is the best way to get it replaced? it currently does not have a smartnet contract, do we need to purchase one and then get it swapped? thanks
