Hi All,I have a 4503-E on my work bench. It's been out of production for a year or so. I started working on it last week. I think I may have cause a boot up problem. It comes up to ROMMON, but then I need to type "boot" to get it to come up all t...
Hi All,Easy question here. I have a Cisco 2960 48-port switch. I enter "sh vlan" and it lists all the VLAN's. One of the VLAN's listed is "10" with the name "EPIC". What is the quickest way to find out what ports, if any, are assigned to this VLA...
Hi All,I'm trying to download firmware for my 1252 access point. When I browse to the proper location (http://www.cisco.com/cisco/software/type.html?mdfid=281235915&flowid=6779), there are two choices (IOS software and Lightweight IOS software). Ho...
Hi All,We have a 4402 Wireless Controller. However, our AP's are from another manufacturer (Meraki MP12). Is it possible that the 4402 can "control" the Meraki MP12? Thanks - Joe
Hi All,I have the 1152 connected to a Linksys router. My PC is connected to the same Linksys router. My PC is 192.168.1.101. The AP is 192.168.1.102. I can ping it fine. I put 192.168.1.102 in my browser and I get nothing. Says IE cannot display the ...
Mohammad,Below is the config with the changes you suggested. It is working now. Thanks again.RG-4503#RG-4503#RG-4503#sh run | include bootboot-start-markerboot system flash bootflash:cat4500-ipbasek9-mz.122-44.SG.binboot-end-markerRG-4503#RG-4503#R...
Reza,Thanks for the information but it didnt work.I went to enable mode and then typed "config t". And then I copied and pasted your command. I did a copy run start, then rebooted.I get the same problem. It stops at rommon. See printout from my ...
Leo,I want the Light Weight software. It's kind of a long story. We aquired a company and they had a couple of these AP's. They sent them to us once we aquired them, but we couldnt get into them (I wasnt really involved at this point). So one of...
