Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Bonjour,J'ai un soucis avec une configuration qui implique un Cisco ASA 5520 et des Linksys WRV2x0 (200 et 210). Il y a aussi des Dlink DI804HV (mais étrangement eux ne pause aucun soucis) :Schéma rapide :LAN1 (1.1.1.x)----(1.1.1.1) ASA5520 (2.2.2.1)...
The web ui on my WRV200s (I have about 100 pieces...) intermittently becomes inaccessible. It usually dies within a day or two, but sometimes it will stay up for a couple weeks. The router still responds to pings while in this state and everything e...
Hello,I try several configuration to make a "correct" Site-to-site VPN between a RV082 (Firmware 2.0.0.19) and a Cisco 2811 (firmware advsecurity 12.4(15)T9 - using SDM interface)A each time the VPN work correctly.... during few minutes and after it ...
Hello,I configure an SPA2102 for a fax (HP 2840 Multifonction Printer).I upgrade SPA2102 to 5.2.10 firmwareWhen I send Fax, all is okBut when I want receive a fax, the fax machine doesn't answer (no ring). I connect an analog phone after the Fax for ...
The WRV210 works fine in the same configuration....: Nicolas MÉRIAN - nmerian@excium.com :.EXCIUM12B Lot la Sagesse97215 Rivière-Salée Tél: 0596 686 686Fax: 0596 686 685Gsm: 0690 34 68 34http://www.excium.com--- --- --- ---
Hello,I try to change the RV082 by a new one with the same configuration, and... nothing The VPN still ok during 3-4 minutes and after I can't acces the 2811 LAN from the RV082 LAN (no ping, and nothing else), but the vpn status stay "UP", I can acce...
Hello,I try several configuration to make a "correct" Site-to-site VPN between a RV082 (Firmware 2.0.0.19) and a Cisco 2811 (firmware advsecurity 12.4(15)T9 - using SDM interface)A each time the VPN work correctly.... during few minutes and after it ...
