Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I configured an ACI Multi-Site deployment with a Bridge Domain stretched between Fabric 1 and Fabric 2.From the control-plane perspective, I can see that the spine switches learn all remote IP/MAC entries via BGP EVPN and correctly install them...
Hello,I configured an ACI Multi-Site deployment with a Bridge Domain stretched between Fabric 1 and Fabric 2.From the control-plane perspective, I can see that the spine switches learn all remote IP/MAC entries via BGP EVPN and correctly install them...
hi @wayneCmiles I usually change it via SSH by connecting to the AP using the default profile credentials. Then, run `show run` to identify the associated WLC. After that, change the WLC using the command `capwap ap primary-base <WLC-NAME> <WLC-IP>`,...
hi @palani2010 I usually change it via SSH by connecting to the AP using the default profile credentials. Then, run `show run` to identify the associated WLC. After that, change the WLC using the command `capwap ap primary-base <WLC-NAME> <WLC-IP>`, ...
hi @eduard.stoica As you can see, on Spine 1, I have an external eBGP route to 172.19.252.20 (DC2) and an iBGP EVPN route for 172.19.252.75 (DC1).There is no intra-EPG contract being enforced. The weird thing is that iping -V doesn’t work, and evensh...
hi @SIMMN You don’t need two separate L3Outs. A single L3Out is sufficient.https://unofficialaciguide.com/2017/08/03/l3out-connecting-to-activestandby-fw/
