Does anyone know if any cisco ASA version supports Micro-BFD (RFC 7130) ?I'm having a hard time finding it in the documentation so probably not.maybe in an upcoming release?
Hi There, I have 16 internal networks 172.28.43.0/25 & 172.28.44.0/25 numbered up etc. etc.Now i have 2 VPN connections that both need to connect to all these networks but only for 1 VPN the complete networks need to be natted to 172.26.43.x/25 172.2...
Hi there, Is it a problem to give 2 single homed fabric extenders to the same Vpc domain the same fex & Portchannel numbers? (see the attached diagram) The problem i'm having is when i move host ports from an old 6513 to the new fex'es it can take a ...
Hi There,Does anyone have a link to an overview of the Port to Asic configuration of the Cisco Catalyst 4500-XI was watching a recorded cisco live presentation and the attached slide came up. (look at bullet point 4)Unfortunately the presenter did no...
Hi,Is it possible to upgrade the IOS on a cisco 3850 stack in a non disruptive way?Reloading 1 switch at a time?Or do you need to reload the entire stack at once, like a 3750 stack?
So it depends on the hashing of the port-channel, not all bgp neighbors go down just the ones that travel over the link that is being pulledlets's say:bgp neigbor A travels over link 1 of the port-channel (because of src-dst ip hashing)bgp neigbor B ...
ebgp CAN be multi hop but it's not in this case the bgp neighbours are on the same segement.I also don't read in the documentation that when you use bgp it MUST be multihop bfd i see loads of examples where it is single hop.or maybe i'm misunderstand...