Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,I need help as I need to allow Public IP address to access Internal MS SQL Server via 1433 port. Below are the details.Public Source IP 200.x.x.9Internal Server Private Addess 10.x.x.126 (this server have a shared Public IP address as well)...
Hello All,We recently adopted Dot1x with IBNS 1.0 on out access switches. For management and better control we want to reduce the commands on the ports. We cannot use templates/macros as below commands are not supported by it. We also cannot use aaa ...
Hi,I can't see profile of new AP on ISE.Can anyone help me create or Import new Profile for AP CW9176I. We have ISE 3.1 for AP profiling. Thankyou in advance. Regards,Aamir Bhatti
Thanks @MHM Cisco World and @paul driver. problem was resolved, apologies for the delayed reply. Just to share with you it was a prefilter policy that was stopping the traffic. Appreciate your help.
Hello Paul,Thankyou for your reply, actually I have tired creating the Access Control policy, and NAT rule on FMC for the respective FTD. But I believe I am missing some steps or not putting the Vendor Public IP at the right place. Public Source IP 2...
Thankyou so much for your reply, actually its for a new AP was not available on ISE 3.1. So I have to create is manually.I was managed to create the profile and fix all the issues.
