Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This is not a question because I found my own answer, but I am posting this for those with the issue of the MWI not clearing after clearing v/m on their service:Open the Configuration Utility, log in as admin, and go to advanced, and under the Ext (1...
Just recently I was viewing my Configuration Utility and then the next time I attempted to connect, it asked for a log in that I was never presented with prior in all the years I have had my SPA303. I have spent numerous hours trying to track down w...
My issue is that after setting a new password in my SPA303 from the deskset, I can no longer log into the Configuration utility. It now asks for a user name/password and will not accept anything I put into it, so I am totally lost. How this started...
Yesterday I viewed my settings in the Configuration Utility but could not find what I was looking for. I had been unable to retrieve my v/m messages because I forgot my password, so I reset it from the desk set. Now I am able to retrieve my v/m mes...
In honor of the time you spent responding to my comments, I will again thank you. You should know, however, that I have read both the Administrator's and User's guide. In addition, I have upgraded my phone's firmware, provisioned it with my SIP pr...
Dan, I appreciate the warning. Just remember, Cisco sells these phones to Small businesses and as such, there are features on the phone that yield surprising results to an end-user like me. Either Cisco should lock out these features, or provide i...
Dan, I am surprised that you do not know what the "SPA Program" is. You seem to be the only responder on the subject of SPA 303 Configuration Utility, so one assumes you are SME. Ask someone else how to access the program stored in the file "/opt/S...
Found the answer to my own question. I reset the password back to the factory default value of blank from the 303 deskset and access was restored. Cisco is remiss in not making this clear in the operating instructions. DO NOT USE THE PASSWORD RESE...
I had a similar problem logging into the CU after changing the password from the default. Once I changed it back to the default value of blank, I was able then to gain access without the password login prompt. If anyone is reading this, the short s...
